Engineering, 22.02.2021 19:10 skent1423

We have a hot tub that contains 450 gallons of water. We added too much chlorine and want to add water from our hose to dilute the chlorine. Initially the concentration of chlorine is 10 mg/L. The water in the hose contains a concentration of chlorine equal to 0.5 mg/L. We allow water to drain out of the bottom while we add the water to maintain a constant height of water. The water leaves the hose at 1 gallon per minute. a. Write a material balance on the chlorine in the hot tub.
b. What is the concentration of the chlorine at steady-state? (when time is at infinity)
c. What is the concentration of chlorine after 100 minutes? 1000 minutes?
d. Graph the concentration of chlorine as a function of time.
e. When will the concentration of chlorine be equal to 1.5 mg/L? 0.6 mg/L?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

You know the right answer?

We have a hot tub that contains 450 gallons of water. We added too much chlorine and want to add wat...

Questions