Engineering, 22.02.2021 02:10 stranger123

Based on your recommendation, the company changed their material but selected a material, which was irrelevant to your suggestion due to cost. They begin to produce forging die made of D3 tool steel but it fractured after only a short service life. The cause of the failure was found to be severe carbon segregation. A client has asked for your recommendation for correction of this problem. In response to this request, please address the topics (a) to (c) first and then provide your recommendation. (a) Find out the nominal composition of D3 tool steel.
(b) Is this steel suitable for such applications? Why?
(c) Why is D3 tool steel prone to severe carbon segregation?
(d) Provide your recommendation to correct the problem. (Your can recommend changing materials, modifying the heat treatment schedule, or anything else you think will work. Remember, this is a real-world problem; thus, the solution is not bounded by anything.)

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

You know the right answer?

Based on your recommendation, the company changed their material but selected a material, which was...

Questions