Engineering, 15.02.2021 19:00 hanz73
Click this link to view O*NET’s Work Activities section for Graphic Designers. Note that common activities are listed toward the top, and less common activities are listed toward the bottom. According to O*NET, what are common work activities performed by Graphic Designers? Check all that apply.
assisting and caring for others
performing general physical activities
interacting with computers
maintaining mechanical equipment
thinking creatively
getting information
Answers: 1
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Click this link to view O*NET’s Work Activities section for Graphic Designers. Note that common acti...
Mathematics, 21.01.2021 02:00
Advanced Placement (AP), 21.01.2021 02:00
Mathematics, 21.01.2021 02:00
Mathematics, 21.01.2021 02:00
Mathematics, 21.01.2021 02:00
Mathematics, 21.01.2021 02:00
History, 21.01.2021 02:00
History, 21.01.2021 02:00
Mathematics, 21.01.2021 02:00
English, 21.01.2021 02:00