subject
Engineering, 08.02.2021 19:20 renegade2020

Assume that you have an incoming stream that contains 106 kg of wet gas (74.2 wt% methane, 15.6 wt% ethane, 5.5 wt% propane and the rest butane). The incoming stream is sent it to a separator (S1). Three streams leave the separator. Stream 2 is the top stream and contains only methane and ethane. Stream 2 contains 98% of the methane fed to the separator. Stream 3 is the middle stream and contains no butane. For every kg of methane in stream 3, there are 2.5 kg of ethane and 1.5 kg of propane. Stream 4 is the lower stream and contains only ethane, butane and propane. The mass flowrate of stream 4 is 10% of the incoming mass flowrate. Stream 4 is then sent to another separator (S2). Stream 5 leaves the top of S2 and contains 80% of the ethane and 50% of the propane entering S2 along with butane. Stream 6 leaves the bottom of S2 and contains all three components. The mass fraction of butane in stream 6 is 0.60. a. Draw and Label the diagram
b. Write equation(s) for the following statements:
1. For every kg of methane in stream 3, there are 2.5 kg of ethane and 1.5 kg of propane.
2. Stream 2 is the top stream and contains 98% of the methane fed to the separator.
3. The mass flowrate of stream 4 is 10% of the incoming mass flowrate.

c. Calculate the mass fraction of ethane in stream 2.
d. Calculate the mass of propane in stream 4.
e. Calculate the mass of butane in stream 5

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
question
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
question
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
You know the right answer?
Assume that you have an incoming stream that contains 106 kg of wet gas (74.2 wt% methane, 15.6 wt%...
Questions
question
Mathematics, 07.10.2019 02:30
question
Mathematics, 07.10.2019 02:30
Questions on the website: 13722359