Would anyone be able to tell me what this is? it's for a water pump
...
Engineering, 03.02.2021 21:50 HTTYD
Would anyone be able to tell me what this is? it's for a water pump
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
Mathematics, 10.03.2021 22:50
Mathematics, 10.03.2021 22:50
Mathematics, 10.03.2021 22:50
Mathematics, 10.03.2021 22:50
Biology, 10.03.2021 22:50
Mathematics, 10.03.2021 22:50
English, 10.03.2021 22:50
Mathematics, 10.03.2021 22:50
Geography, 10.03.2021 22:50
Geography, 10.03.2021 22:50
Mathematics, 10.03.2021 22:50
SAT, 10.03.2021 22:50