Engineering, 27.01.2021 20:20 rashawng2005

For the following production environments, indicate whether the preferred production system is more likely to be a job shop (process layout), production line (product layout), batch process (group technology layout), or hybrid. Provide support for your answer. a. Manufacturer of Clothes: makes many styles (shirts, pants, coats, rain jackets, etc.) and sells to small specialty stores.
b. Manufacturer of Gaskets: makes styles for 4-5 engine blocks: sells to GM and Ford (i. e., high volume).
c. Independent Automobile Service Shop: body work, general service, engine repair, serving many makes of automobiles.
d. Producer of Pharmaceutical Drugs: make approximately 50-75 drugs in tablet form: sell to pharmacies nationwide.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

Answer

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

You know the right answer?

For the following production environments, indicate whether the preferred production system is more...

Questions