subject
Engineering, 26.01.2021 18:50 lauranfamily

A front wheel drive vehicle with four wheel disc brakes is pulling to the left. Tech A says an external kink or internal restriction in the LF brake line will result in this condition. Tech B says to use a compression fitting to repair a section of brake line. Who is correct? Tech A Tech A Tech B Tech B Both Both Neither

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false
Answers: 3
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
You know the right answer?
A front wheel drive vehicle with four wheel disc brakes is pulling to the left. Tech A says an exter...
Questions
question
Mathematics, 21.12.2021 15:40
question
Mathematics, 21.12.2021 15:40
Questions on the website: 13722363