Engineering, 21.01.2021 22:40 soleil26

Please help ( true or false questions)69. Secure the work with clamps or the vise. _70. Check to see the sanders switch is in the on position before plugging in
-71. Replace sandpaper after plugging into the electrical outlet.
72. Tuming offthe dust collection system.
73. Don't force the machine. Use only the weight of the machine to do the
sanding
74. Watch where the cord is so you get it caught in the machine.
75. Don't put the machine down until it stops moving.
76. Pretend the sander is a race car and has to be revved up so you look cool.
Saber Saw Test
77. Wear safety glasses.
_78. Make all adjustments with the power cord plugged in.
79. Check to see that the switch is off before plugging in the machine.
80. Overload the machine by cutting too fast.
Meeting in "General
81. Keep fingers and power cords a safe distance from the blade.
RS
82. Use a four inch safety margin.
83. Make relief cuts to avoid tuming the blade too sharp.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

You know the right answer?

Please help ( true or false questions)69. Secure the work with clamps or the vise. _70. Check to se...

Questions