Engineering, 20.01.2021 18:00 rlafferty5604

1. For the following products; what are the appropriate material selection criteria? What type of criteria should be considered? Why? Compare them with your own
words.
What are the alternative materials? Describe the selected materials (Such as; 1040
plain carbon steel and Al 5083) in detail including properties, advantages and
disadvantages, application areas etc. Compare them with your own words.
Select the suitable material and list the alternative materials from the best to the
worst according to the criteria you have set. Discuss the results using your own
words.
a) Suitable material for armor protection. Choose the material considering with
and without the density?
b) Automobile exhaust system
c) Wind turbine blade
2. What type of manufacturing processes can be used to produce the abovementioned parts using selected materials? Select a suitable manufacturing
technique between alternatives. Discuss the selection criteria and the results using
your own words.
3. What is the relationship between material selection and design? Explain in
detail using your own words.
4. What is the relationship between material selection and manufacturing? Explain
in detail using your own words.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

What is the main objective of using reheat rankine cycle?

Answers: 3

Answer

You know the right answer?

1. For the following products; what are the appropriate material selection criteria? What type of c...

Questions