Engineering, 18.01.2021 14:00 gl648809

A shell-and-tube heat exchanger is to heat 10,000 kg/hr of water from 16 oC to 84 oC by hot engine oil flowing through the shell. The oil makes a single shell pass, entering at 160 oC and leaving at 94 oC, with an average heat transfer coefficient of 400 W/m2K. The water flows through 11 brass tubes of 22.9 mm inside diameter and 25.4 mm outside diameter, with each tube making 4 passes through the shell. Required:
a. Assuming fully developed flow determine the required tube length per pass.
b. For the tube length found in part (1), plot the effectiveness, fluid outlet temperatures, and water-side convection coefficient as a function of water flow rate for 5000 <=15,000 kg/h, with all other conditions remaining the same.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Prove the equivalence between the two statements of the 2nd law of thermodynamics (i.e., a violation of one statement leads to the violatio the other statement)

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Which of the following is the most important advantage of a large field of view? a. allows larger areas to be examined b. relieves eyestrain c. minimizes parallax errors. d. increases precision in proportion to the in- crease in field of view

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

You know the right answer?

A shell-and-tube heat exchanger is to heat 10,000 kg/hr of water from 16 oC to 84 oC by hot engine o...

Questions