Engineering, 18.01.2021 14:00 carrietaylor234
A medium drive of a steel hub of a gear with an outside diameter of 80 mm on a steel shaft is required. a) Make the dimensional decisions for a 49-mm basic size with a medium drive fit for the hub and shaft, and specify dimensions with tolerances for the shaft and the hub bore for the fit. b) When the interference pressure “p” is at a minimum (p at δmin) for the specified tolerances how much torque (in Nm) can be transferred with the medium drive fitted assembly if the steel to steel friction is 0,8 and the hub of the length is 170 mm. E=207 GPa
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 06.07.2019 03:20
Not a characteristic property of ceramic material (a) high temperature stability (b) high mechanical strength (c) low elongation (d) low hardness
Answers: 2
Engineering, 06.07.2019 04:20
Amachine of mass 140 kg is mounted on springs of stiffness 1.4x10° n/m and in parallel witha viscous damper of unknown damping coefficient. the machine is subject to a harmonic excitation of 200sin150t n. the phase angle is measured as 2.58 rad. what is the damping coefficient of the viscous damper?
Answers: 2
You know the right answer?
A medium drive of a steel hub of a gear with an outside diameter of 80 mm on a steel shaft is requir...
Questions
Mathematics, 29.03.2021 16:40
Social Studies, 29.03.2021 16:40
Mathematics, 29.03.2021 16:40
Mathematics, 29.03.2021 16:40
Spanish, 29.03.2021 16:40
English, 29.03.2021 16:40
Mathematics, 29.03.2021 16:50
Biology, 29.03.2021 16:50
Mathematics, 29.03.2021 16:50
