subject
Engineering, 16.01.2021 03:00 amandavertre

Type the correct answer in the box. Spell all words correctly. What type of foundation will Marcus use to construct a building with a basement?
Marcus is in charge of constructing a building that has a basement. The entire basement floor is supposed to bear the building’s load and act as the foundation. Marcus will use a NEEDS ANSWER
foundation, which is useful in situations where soils have a weak soil bearing capacity.
Reset Next

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
You know the right answer?
Type the correct answer in the box. Spell all words correctly. What type of foundation will Marcus...
Questions
question
Mathematics, 12.01.2021 23:20
question
Mathematics, 12.01.2021 23:20
question
Mathematics, 12.01.2021 23:20
question
Mathematics, 12.01.2021 23:20
question
English, 12.01.2021 23:20
question
Arts, 12.01.2021 23:20
question
Mathematics, 12.01.2021 23:20
Questions on the website: 13722362