Engineering, 14.01.2021 15:00 dontcareanyonemo

Equilateral triangular sewer, 1.5 m on each side, constructed of concrete, used to drain at a flow rate of 1000 kg / m 5, with the effluent density of 1100 kg / m and viscosity of 1.25 cP, length 10. km before entering the center. Calculate 1.1 The area of contact with the sewage of the pipe (Perimeter of pipe, P) is equal to how many meters?
1.2 The cross-sectional area of the sewer. (Goss-sectional are, A) is how many square meters?
1.3 What is the hydraulic radius, R. Since the in-pipe flow (h) is equal to the water meter when calculated with the Hazen Williams Formula, it has a Hazen-Williams constant of 110 1.6 What is the system pressure drop in kPa 1.7 The power of the pump at How many watts must be compensated for the system when the pump efficiency is 0.85 1.8 Reynolds number of particles?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 19:20

A21-tooth spur pinion mates with a 28-tooth gear. the diametral pitch is 3 teeth/in and the pressure angle is 20°, find the following values: the addendum, dedendum, circular pitch, tooth thickness, and base circle diameters.

Answers: 2

Answer

You know the right answer?

Equilateral triangular sewer, 1.5 m on each side, constructed of concrete, used to drain at a flow r...

Questions