subject
Engineering, 23.12.2020 18:20 toxsicity

Question # 1 File Upload

In your memo, be sure to discuss the amount of creativity exercised in selecting materials like these. Also reference the article you read.

Submit your work.
New Directions in Residential Construction
Several states and their communities suffered devastation following Hurricane Katrina. Thousands of homes were destroyed or so impregnated with mold following the flooding that they became permanently uninhabitable. The Federal Emergency Management Agency (FEMA), which is part of the Department of Homeland Security has been working with state and local governments to develop innovative and affordable modular housing that can be moved from one location to another with minimal expense. Read this article on cutting-edge modular homes: about the Alabama pilot project on the FEMA website at https://www. fema. gov/alabama-alternative-housing-pil ot-program

You work for a high-end residential construction firm. In the past, "modular homes" was a buzzword for "trailer home" and definitely nothing a residential construction firm like yours would want to be associated with, but times are changing. People are asking for new options and wanting to leave a smaller carbon footprint, for one thing. Another issue is that clients are asking about using recycled and reused materials in their home design, and asking that your firm create designs with these materials.

Your boss wants you to research the potential of designing and creating high-end modular homes for clients.

In a short paper written like an informal memo to your boss, take a position on the following:

whether your firm should start creating cutting-edge modular home designs; and
whether your firm should start creating designs with recycled and reused materials in used builds.
In your memo, be sure to discuss the amount of creativity exercised in selecting materials like these. Also reference the article you read. It is fine to use a conversational tone and the first person, and even to use bullet points and lists.

You should be able to answer these questions thoroughly in two pages or less.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
question
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
question
Engineering, 04.07.2019 19:10
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
You know the right answer?
Question # 1 File Upload

In your memo, be sure to discuss the amount of creativity exerc...
Questions
question
Chemistry, 06.09.2021 22:30
Questions on the website: 13722363