When I’m the imposter I’m among us
...
Answers: 2
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Social Studies, 16.02.2021 15:10
Mathematics, 16.02.2021 15:10
Chemistry, 16.02.2021 15:10
Social Studies, 16.02.2021 15:10
Chemistry, 16.02.2021 15:10
English, 16.02.2021 15:10
Physics, 16.02.2021 15:20
Social Studies, 16.02.2021 15:20
Physics, 16.02.2021 15:20
Mathematics, 16.02.2021 15:20
Mathematics, 16.02.2021 15:20
Mathematics, 16.02.2021 15:20