Engineering, 09.12.2020 07:00 icecreamisgood4u
Which of the following is an acronym used in mechanical plans?
Answers: 1
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Which of the following is an acronym used in mechanical plans?...
English, 05.10.2020 05:01
Mathematics, 05.10.2020 05:01
Mathematics, 05.10.2020 05:01
Chemistry, 05.10.2020 05:01
Mathematics, 05.10.2020 05:01
Mathematics, 05.10.2020 05:01
Mathematics, 05.10.2020 05:01
Mathematics, 05.10.2020 05:01
Social Studies, 05.10.2020 05:01
Geography, 05.10.2020 05:01