Engineering, 08.12.2020 01:00 biancasamadp3usfw
Fran has a job involved with controlling the flow of oil through a series of pipelines at the refinery. As a part of his work, he needs to interpret diagrams, levels, and readings from gauges. He also needs to be ready with the appropriate procedures in case of an emergency. Which career pathway does Fran most likely work in based on these tasks?
Answers: 1
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Fran has a job involved with controlling the flow of oil through a series of pipelines at the refine...
Engineering, 27.10.2020 18:50
Mathematics, 27.10.2020 18:50
Mathematics, 27.10.2020 18:50
Mathematics, 27.10.2020 18:50
Computers and Technology, 27.10.2020 18:50
Arts, 27.10.2020 18:50
Social Studies, 27.10.2020 18:50
Computers and Technology, 27.10.2020 18:50
Social Studies, 27.10.2020 18:50
Mathematics, 27.10.2020 18:50
Computers and Technology, 27.10.2020 18:50
Biology, 27.10.2020 18:50
Mathematics, 27.10.2020 18:50