Engineering, 07.12.2020 17:00 watsonjessalynn

A 2½ × 2½-in sleeve bearing uses grade 20 lubricant. The axial-groove sump has a steady-state temperature of 110°F. The shaft journal has a diameter of 2.500 in with a unilateral tolerance of –0.001 in. The bushing bore has a diameter of 2.504 in with a unilateral tolerance of 0.001 in. The journal speed is 1120 rev/min and the radial load is 1200 lbf. Estimate (a) The magnitude and location of the minimum oil-film thickness.

(b) The eccentricity.

(c) The coefficient of friction.

(d) The power loss rate.

(e) Both the total and side oil-flow rates.

(f) The maximum oil-film pressure and its angular location.

(g) The terminating position of the oil film.

(h) The average temperature of the side flow.

(i) The oil temperature at the terminating position of the oil film

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?

Answers: 1

Answer

Engineering, 04.07.2019 19:10

What is the main objective of using reheat rankine cycle?

Answers: 3

Answer

You know the right answer?

A 2½ × 2½-in sleeve bearing uses grade 20 lubricant. The axial-groove sump has a steady-state temper...

Questions