subject
Engineering, 04.12.2020 21:30 TheOneandOnly003

To make a proper glue joint, you must . 10 points
a. have the surfaces rough to make the glue sink in and stick better.
b. have the surfaces wet or at least damp to help the glue sink into the surfaces.
c. have the surfaces of the wood a bit wavy to allow for pockets of glue to form.
d. have the surfaces clean and smooth for a good fit up.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
question
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
question
Engineering, 06.07.2019 02:30
Define thermoplastic polymers and thermosetting polymers in terms of their structures, and (ii) describe briefly a process suitable for the production of products from each type of polymer.
Answers: 3
You know the right answer?
To make a proper glue joint, you must . 10 points
a. have the surfaces rough to make the glu...
Questions
question
Mathematics, 18.03.2021 02:30
question
English, 18.03.2021 02:30
question
Mathematics, 18.03.2021 02:30
question
Mathematics, 18.03.2021 02:30
question
Mathematics, 18.03.2021 02:30
Questions on the website: 13722367