Engineering, 01.12.2020 17:00 emmaty7845

25points and brainliest if correct A, B, C, D Which option distinguishes the most appropriate action to take next in the following scenario?
Lisa is a new worker on a farm. She needs to access an area of the farm at the top of the hill on a tractor. She tries backing the tractor up the slant and finds that it will not make the ascent.

A. Lisa should drive across the hill at an angle to get to the top.
B. Lisa should reach the top of the hill by finding a less steep path.
C. Lisa should drive forward up the hill at a slow pace to get to the top.
D. Lisa should reach the top of the hill by finding a more experienced driver.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

Engineering, 06.07.2019 03:20

What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.

Answers: 3

Answer

Engineering, 06.07.2019 03:20

Explain in your own word the concept of a solid solution, in alloys, and how it can be created.

Answers: 3

Answer

You know the right answer?

25points and brainliest if correct A, B, C, D Which option distinguishes the most appropriate actio...

Questions