Engineering, 18.11.2020 17:30 itzyagirlshy

An element is subjected to plane stress. By rotating 20 degrees in the clockwise direction from its original position, the element can reach its principal stress state. Which rotation of the element from its original position can reach the state of maximum in-plane shear stress? a) 25 degrees in the counterclockwise direction
b) 70 degrees in the clockwise direction
c) 45 degrees in the clockwise direction
d) 45 degrees in the counterclockwise direction
e) 70 degrees in the counterclockwise direction
f) 25 degrees in the clockwise direction

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

You know the right answer?

An element is subjected to plane stress. By rotating 20 degrees in the clockwise direction from its...

Questions