Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
Engineering, 04.07.2019 19:20
List 3 options on how to reduce knocking problens during engine process,
Answers: 2
Engineering, 06.07.2019 02:30
On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)
Answers: 2
You know the right answer?
Which circuit is known as electronic circuit?...
Questions
Mathematics, 09.03.2021 23:20
Spanish, 09.03.2021 23:20
Mathematics, 09.03.2021 23:20
Mathematics, 09.03.2021 23:20
Mathematics, 09.03.2021 23:20
Mathematics, 09.03.2021 23:20
Physics, 09.03.2021 23:20
English, 09.03.2021 23:20
Mathematics, 09.03.2021 23:20
English, 09.03.2021 23:20
Business, 09.03.2021 23:20
Mathematics, 09.03.2021 23:20
Mathematics, 09.03.2021 23:20
Arts, 09.03.2021 23:20
