Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Im a smol babyi need a daddy tho :(...
World Languages, 10.11.2021 02:00
Mathematics, 10.11.2021 02:00
Mathematics, 10.11.2021 02:00
Chemistry, 10.11.2021 02:00
Mathematics, 10.11.2021 02:00
Mathematics, 10.11.2021 02:00
Mathematics, 10.11.2021 02:00
Health, 10.11.2021 02:00
Biology, 10.11.2021 02:00
Mathematics, 10.11.2021 02:00
Mathematics, 10.11.2021 02:00