Engineering, 10.11.2020 01:00 brendaesme

A block is sliding down an incline of 60 degrees as shown in the figure below. The coefficient of friction, μ , of the surface of the incline plane is 0.3. The frictional force is = μ where is the normal force. The weight of the block is W. Assume the acceleration due to gravity is 9.8 m/ 2 (a) Provide the expression for the component for the Weight force in the direction along the incline plane.
(b) Provide the expression for the component for the Weight force in the direction perpendicular to the incline plane.
(c) Provide the expression for the normal force in terms of W.
(d)
Provide the expression for in terms of W.
(e) Provide the equation for the sum of the forces in the direction along the incline plane (include appropriate signs).
(f) Provide the equation for the sum of the forces in the direction perpendicular to the incline plane (include appropriate signs).
(g) What is the value for acceleration of the block along the incline plane?
(h) How far (in meters) will the block slide in 10 seconds if it is released from rest?

A block is sliding down an incline of 60 degrees as shown in the figure below. The coefficient of f

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.

Answers: 3

Answer

Engineering, 06.07.2019 02:30

On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)

Answers: 2

Answer

You know the right answer?

A block is sliding down an incline of 60 degrees as shown in the figure below. The coefficient of fr...

Questions