Help me plz
External Forces
Rky=
Rmx=
Rmy=
Internal Forces (be sure to labe...
Engineering, 06.11.2020 17:50 Clerry
Help me plz
External Forces
Rky=
Rmx=
Rmy=
Internal Forces (be sure to label c for compression and t for tension)
KL=
LM=
KM=
Answers: 1
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
Geography, 12.11.2020 20:10
Biology, 12.11.2020 20:10
English, 12.11.2020 20:10
Biology, 12.11.2020 20:10
Health, 12.11.2020 20:10
Chemistry, 12.11.2020 20:10
Mathematics, 12.11.2020 20:10
History, 12.11.2020 20:10
Mathematics, 12.11.2020 20:10
English, 12.11.2020 20:10
Mathematics, 12.11.2020 20:10