Engineering, 06.11.2020 01:00 Malari4445

The essay or report should: Name the product and briefly describe it. Identify the types of engineering that would be used to develop the product. Describe how you would apply the stages of the product life cycle to your product. Generally describe the steps that you would take within each step, using your product as an example. End with a short conclusion based on what you believe the outcome would be if you followed the product development life cycle process. (I NEED IT FAST AND IT NEEDS TO BE ANYTHING AND IF YOU JUST PUT A RANDOM THING YOU WILL BE REPORTED AND JUST PLEASE PUT YOUR BEST ANSWER! ILL MARK YOU AS BRAINLIEST)

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?

Answers: 3

Answer

You know the right answer?

The essay or report should: Name the product and briefly describe it. Identify the types of engineer...

Questions