subject
Engineering, 28.10.2020 16:40 719729

A series composite wall of a furnace consists of 20 cm of fire brick (thermal conductivity 1.4 W/m-K), 10 cm of insulating material (0.22 W/m-K), 10 cm of ordinary brick (0.90 W/m-K), and 10 cm of asbestos cement board (0.39 W/m-K). The inside of the furnace wall is 560C and temperature of the outside wall is 80C. The heat transfer rate through the wall per area is most nearly:

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
A series composite wall of a furnace consists of 20 cm of fire brick (thermal conductivity 1.4 W/m-K...
Questions
question
World Languages, 19.10.2019 00:30
question
History, 19.10.2019 00:30
question
Computers and Technology, 19.10.2019 00:30
Questions on the website: 13722363