Engineering, 28.10.2020 01:00 jessiegarrison1

Can anyone help me with my welding work plz? I really need help so plz help I was supposed 2 turn this in 5 hours ago. There are 12 questions.

The step motion (we call it the stitch motion), is used with what type of welding electrodes?

What type of penetration is gained by using the step motion technique?

A vertical weld can be made in which directions?

Which vertical technique is the easiest to perform?

What technique or motion is used when welding in the horizontal position?

6013 electrodes were designed to weld; what material, in what polarity, while traveling in what direction?

What is the recommended amperage to be used when welding a ⅛” 6013 electrode in AC?

If you make a small weld, what can be done to correct this problem according to the video?

What solidifies first when welding with 7018, the poodle or the flux?

What is porosity?

What can cause porosity?

When using a ⅛” 7018 electrode in DC+, when is the suggested amperage?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

Answer

You know the right answer?

Can anyone help me with my welding work plz? I really need help so plz help I was supposed 2 turn th...

Questions