Engineering, 21.10.2020 16:01 jeremy7131

Consider a full bridge Wheatstone Bridge circuit, with two strain gages placed on top of a cantilever beam and two strain gages placed on the bottom (all gages oriented parallel to the beam). Assume that the supply voltage to the circuit is 8 Volts, a gage factor of 2.2, Poisson's ratio of 0.34. If the gages are strained by 10.9 microstrain, what will be the measured voltage? Your answer should be given in units of mV.(i know the answer is 0.170100 mV but idk how)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

You know the right answer?

Consider a full bridge Wheatstone Bridge circuit, with two strain gages placed on top of a cantileve...

Questions