Engineering, 13.10.2020 15:01 Yellow78
What are the benefits of using a multi view sketch to communicate a design
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
What are the benefits of using a multi view sketch to communicate a design...
Questions
Chemistry, 20.04.2021 06:40
Mathematics, 20.04.2021 06:40
Mathematics, 20.04.2021 06:40
Mathematics, 20.04.2021 06:40
Mathematics, 20.04.2021 06:50
Chemistry, 20.04.2021 06:50
Mathematics, 20.04.2021 06:50
Mathematics, 20.04.2021 06:50
Mathematics, 20.04.2021 06:50
Mathematics, 20.04.2021 06:50
Mathematics, 20.04.2021 06:50
