subject
Engineering, 08.10.2020 02:01 Jana1517

Alternatively, the general contractor could do the work using their own excavator. They have a CAT 349F L with a Long Reach Boom, (Belgium Sourced) with a 80 in. wide General Duty High Capacity bucket. The contractor has no trench box and the side slopes of the trench will have to be at a 1:1 slope to the bottom of the trench in order to be safe. The bottom of the trench will be 6.6 feet wide (due to size of bucket). Without the trench box, the contractor estimates it will take 10 minutes to lay a joint of pipe. Could the job be completed more quickly with the CAT 349F L

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.
Answers: 1
question
Engineering, 04.07.2019 19:20
To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.
Answers: 1
question
Engineering, 04.07.2019 19:20
Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference
Answers: 3
question
Engineering, 06.07.2019 04:20
Consider the transfer function for a first-order system g(s)=12(s+7)/(s^2+2s+9) for this system determine: a) poles and zeros of the function, b) the natural frequency and damping ratio, c) the peak value achieved in response to a unit step input, d) the peak time for a unit step input, e) the steady-state system response to a unit step input
Answers: 2
You know the right answer?
Alternatively, the general contractor could do the work using their own excavator. They have a CAT 3...
Questions
question
Mathematics, 18.02.2021 05:30
question
Mathematics, 18.02.2021 05:30
question
Mathematics, 18.02.2021 05:30
question
Mathematics, 18.02.2021 05:30
Questions on the website: 13722362