Engineering, 02.10.2020 09:01 gggggggggggg5496

A student is measuring the effects of an electric circuit on a compass, and he is testing to see if increasing the current will cause the compass needle to change its direction faster. He does one trial using a 9-volt battery and another trial using a 1.5-volt battery. He takes accurate data. Based on good experimental design, what would improve his experiment? A) He should repeat the test with three additional batteries of varying voltages to demonstrate the reproducibility of results.

B) He should use only one battery but do several trials, using different circuit designs to ensure he has appropriate test groups.

C) He should add a nonworking compass to act as a control.

D) He should use batteries of the same voltage but from different manufacturers to show he has used different variables.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Aplate of dimensions 3 m x 3 m is placed 0.37 mm apart from a fixed plate. the plate requires a force of 2n to move at speed of 45 cm/s. evaluate the viscosity of the fluid in between the plates

Answers: 3

Answer

You know the right answer?

A student is measuring the effects of an electric circuit on a compass, and he is testing to see if...

Questions