Engineering, 24.09.2020 23:01 Carlos448

1. Use a concentration of 20.0 mg/L for the pollutant (instead of 10.0 mg/L) (Materials Balance, Steady State Conservative System). 2. Use a reaction rate of K=0. 30/day (instead of K = 0.25/day) (Materials Balance, CSTR, 1st Order).
3. The stream has an unknown BOD concentration C0 =? (instead of 20 mg/L). The regulatory limit at the discharge of Pond 2 is 20 mg/L (C2 = 20 mg/l). Find the maximum BO concentration leaving Pond 1 and in the stream (C0 =? and C1 =?).

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

Answer

Engineering, 04.07.2019 18:20

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

You know the right answer?

1. Use a concentration of 20.0 mg/L for the pollutant (instead of 10.0 mg/L) (Materials Balance, Ste...

Questions