Engineering, 23.09.2020 14:01 dekarouh
Slab milling is performed on the top surface of a rectangular workpiece that is 12.0 in long by 2.5 in wide by 4.0 in thick. The helical milling cutter, which has a 3.0-in diameter and eight teeth overhangs the width of the part on both sides. Cutting speed = 125 ft/min, feed = 0.006 in/tooth, and depth of cut = 0.300 in. Determine (a) machining time and (b) maximum metal removal rate during the cut. (c) If an additional approach distance of 0.5 in is provided at the beginning of the pass (before cutting begins), and an overtravel distance is provided at the end of the pass equal to the cutter radius plus 0.5 in, what is the duration of the feed motion.
Answers: 2
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
Engineering, 04.07.2019 19:20
At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2
Answers: 2
Engineering, 04.07.2019 19:20
A5 kg block of fe is dropped into a very large vat of water. the fe and water initial temperatures are 95 and 25 c, respectively. the fe final temperature is 25 c and the water can be treated as a thermal reservoir,. treated as a thermal reservoir take the water to be the system and determine the entropy generation. report vour answer in kj/k.
Answers: 1
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
Slab milling is performed on the top surface of a rectangular workpiece that is 12.0 in long by 2.5...
Mathematics, 22.02.2021 16:40
History, 22.02.2021 16:40
Mathematics, 22.02.2021 16:40
World Languages, 22.02.2021 16:40
Mathematics, 22.02.2021 16:40
French, 22.02.2021 16:40
Computers and Technology, 22.02.2021 16:40
Mathematics, 22.02.2021 16:40
English, 22.02.2021 16:40
Business, 22.02.2021 16:40