Engineering, 23.09.2020 06:01 kivking12

Explain the significance of the following information given in the specification of the transducers. (In other words, define these types of errors and explain what the actual value can be if the measured value is, let's say, M) (15pts) (Problem #2.1 on page 66 modified) (a) A capacitive linear displacement transducer. Non-Linearity and hysteresis: ± 0.01% of full range
(b) A resistance strain gauge force measurement transducer. Temperature sensitivity: ± 1% of the full range over normal environmental temperatures
(c) Inertial measurement unit rate gyroscope for angular velocity measurement Repeatability: ± 0.01% of full range

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

You know the right answer?

Explain the significance of the following information given in the specification of the transducers....

Questions