subject
Engineering, 21.09.2020 14:01 northpolea

Which statement best describes how scientists and engineers work together in the research and development cycle?
A. Scientists develop a new technology, and then engineers test it by
doing experiments.
B. Engineers make a scientific discovery, and then scientists perform
research to verify it.
C. Scientists test designs made by engineers and then use the
results to improve the designs.
D. Engineers come up with scientific questions when they are
developing their design, and scientists do research to answer
them.

(this is for apex. i’d love if you could help me <33)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
question
Engineering, 04.07.2019 18:10
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k
Answers: 2
You know the right answer?
Which statement best describes how scientists and engineers work together in the research and devel...
Questions
question
History, 08.03.2021 01:00
question
Mathematics, 08.03.2021 01:00
question
Mathematics, 08.03.2021 01:00
question
Mathematics, 08.03.2021 01:00
question
Mathematics, 08.03.2021 01:00
Questions on the website: 13722363