Engineering, 20.09.2020 01:01 babygreg2001p97abr
if the number of teeth in the gears 1 and 2 are 60 and 40,the module pitch =3mm, the pressure angle 20o and the addendum=0.318 of circular pitch determine the velocity of sliding when the contact is at the tip of the teeth of gear 2 and the gear 2 rotates at 800rpm
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
You know the right answer?
if the number of teeth in the gears 1 and 2 are 60 and 40,the module pitch =3mm, the pressure angle...
Questions
Arts, 15.11.2021 01:00
Biology, 15.11.2021 01:00
History, 15.11.2021 01:00
Health, 15.11.2021 01:00
Physics, 15.11.2021 01:00
Mathematics, 15.11.2021 01:00
History, 15.11.2021 01:00
English, 15.11.2021 01:00
Mathematics, 15.11.2021 01:00
Chemistry, 15.11.2021 01:00
