Engineering, 08.09.2020 14:01 EMQPWE
What should be done to reduce refrigerant loss from a purge unit on a r123 chiller?
A. Leak test and repair the chiller.
B. Seal the purge unit discharge line.
C. Pipe purge unit back into the low side.
D. Pipe purge unit back into recovery unit.
Answers: 1
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:20
Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false
Answers: 3
What should be done to reduce refrigerant loss from a purge unit on a r123 chiller?
A. Leak test an...
Mathematics, 21.06.2019 20:00
Mathematics, 21.06.2019 20:00
Social Studies, 21.06.2019 20:00
History, 21.06.2019 20:00
Mathematics, 21.06.2019 20:00
Social Studies, 21.06.2019 20:00
Mathematics, 21.06.2019 20:00