Engineering, 30.08.2020 01:01 brennarfa
In which order are the following measuring instruments listed from lowest precision to highest precision:
Select one:
a. Outside Calipers.
Ruler.
Micrometer.
Digital Calipers.
b. Outside Calipers.
Digital Calipers.
Ruler.
Micrometer.
c. Outside Calipers.
Digital Calipers.
Micrometer.
Ruler.
Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
In which order are the following measuring instruments listed from lowest precision to highest preci...
Social Studies, 15.12.2020 01:00
Mathematics, 15.12.2020 01:00
Mathematics, 15.12.2020 01:00
Mathematics, 15.12.2020 01:00
Mathematics, 15.12.2020 01:00
Chemistry, 15.12.2020 01:00
Mathematics, 15.12.2020 01:00
History, 15.12.2020 01:00