Engineering, 29.08.2020 20:01 mayalp

1)A wheel is used to turn a valve stem on a water valve. If the wheel radius is 1 foot and the stem, (axle), radius is .5 inches, what is the mechanical advantage of the wheel and axle? 2)How much resistance force can ideally be overcome when an effort of 80 lbs is applied to the wheel of the water valve in problem 1?

3)What is the linear distance traveled when a 2.5’ diameter wheel makes one revolution?

4)A compressor motor has a 1.00 inch output shaft (axle) that drives a 4.00inch pulley (wheel). If the motor output shaft supplies 24 lbs of force, ideally how much force does the pulley apply to the drive belt wrapped around it?

5) If the belt pulley’s force is measured to be 4 lbs, what is the AMA wheel and axle here?6) What is the efficiency of the compressor motor – belt pulley wheel and axle?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 06.07.2019 03:10

Oxygen at 300 kpa and 400 k is in a closed system with an initial volume of 0.1 m3. is now compressed in a polytropic process, with exponent of n 1.2, to a temperature of 500 k. calculate: a) the boundary work done during the compression, in kj b) the heat transfer during the compression, in kj

Answers: 3

Answer

You know the right answer?

1)A wheel is used to turn a valve stem on a water valve. If the wheel radius is 1 foot and the stem,...

Questions