Engineering, 15.08.2020 18:01 Scienceissofun6453

A square aluminum plate mm on a side and mm thick and is heated uniformly to C. The plate is vertically suspended in quiescent air at C. Neglect contributions of side surfaces of the plate in convection and radiation calculations. (B) Calculate the net convective heat transfer loss rate from both vertical surfaces of the plate to the air. (Hint: h values should be the same for both surfaces of the vertical plate) (C) Calculate the net radiation heat loss rate to a very large environment at C. Assume it is a two surface enclosure and all surfaces are gray and diffuse. . Do you think you can neglect the net radiation heat loss rate

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

You know the right answer?

A square aluminum plate mm on a side and mm thick and is heated uniformly to C. The plate is vertica...

Questions