Engineering, 14.08.2020 15:01 jocelynbeoletto

The velocity components for a flow of an incompressible fluid are given by the following equations:
u=kx (y + z);
v=ky (x + z);
w=-k z(x + y)- 22.
• Determine the value of “k” in order to have a physically possible flow.
• Determine if the flow is steady or not (use the value of “K”, obtained in the first part).
• Determine if the flow is uniform or not (use the value of “K”, obtained in the first part).
• Determine if the flow is rotational or not (use the value of “k”, obtained in the first part). If it
is a rotational flow, compute the magnitude of rotations at a point A which has the following
coordinates: x=1, y=1, z=1.

The velocity components for a flow of an incompressible fluid are given by the following

equation

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

You know the right answer?

The velocity components for a flow of an incompressible fluid are given by the following equations:...

Questions