Engineering, 12.08.2020 07:01 okme
A 10-inch model pump delivering water at 180F at 800gal/min and 2500 rpm begins to cavitate when the inlet pressure and velocity are 14 psia and 22 ft/s, respectively. Determine the required NPSH for (i) the model and (ii) a prototype which is 5 times larger and runs at 1000 rpm
Answers: 3
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
A 10-inch model pump delivering water at 180F at 800gal/min and 2500 rpm begins to cavitate when th...
Mathematics, 17.05.2021 16:30
Mathematics, 17.05.2021 16:30