Engineering, 01.08.2020 20:01 bdog70

Consider the following amplitudemodulation(AM)transmission system. The input signal is푥푡=%&'++.We first multiply 푥(푡)by 푐표푠(4푡). That is, 푦푡=푥푡⋅푐표푠(4푡).The transmitter then transmits signal 푦(푡)through the antenna. At the receiver side, we first multiply 푦(푡)by 2푠푖푛(4푡). That is 푧(푡)=푦(푡)·2푠푖푛(4푡)and then pass 푧(푡)through a low pass filter with cutoff frequency 푊=7.5푟푎푑/푠푒푐. Denote the final output by 푤(푡)=푧(푡)h퐿푃퐹(푡). 1.Plot the CTFT 푊(푗휔)of 푤(푡)for the range of -10<휔<10. 2.Find the expression of 푤(푡)

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

You know the right answer?

Consider the following amplitudemodulation(AM)transmission system. The input signal is푥푡=%&'+*+....

Questions