Comparator implementation [20]
Submission file for this part: 2.circ
Main circuit name: comp...
Engineering, 29.07.2020 02:01 shawn20034
Comparator implementation [20]
Submission file for this part: 2.circ
Main circuit name: comparison Input pin(s):
inputa [2], inputb [2]
Output pin(s):
areequal [1],
greaterthan [1],
lessthan [1]
Implement a 2-bit comparator.
While already specified above, you may not use anything from the Arithmetic library for this problem. This defeats the purpose of the problem. You must implement your comparator within the constraints specified for this lab.
Answers: 2
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Mathematics, 05.10.2020 14:01
Mathematics, 05.10.2020 14:01
Mathematics, 05.10.2020 14:01
Mathematics, 05.10.2020 14:01
History, 05.10.2020 14:01
History, 05.10.2020 14:01
Mathematics, 05.10.2020 14:01
English, 05.10.2020 14:01
Spanish, 05.10.2020 14:01