Engineering, 05.07.2020 01:01 604341

A Small-sized Wind Turbine is schematically shown in Fig (a), and is delivering a maximum rated power of ( 50 KW ). This Wind Turbine is using " A Single-Stage- Spur- gearbox " to speed up the main Drive shaft speed from 20 rpm to 1400 rpm ( see Fig (b) ). In order to absorb shock loads , such gear box is suspended in space by two torque arms -as shown in Fig ( c ); which is attached to the turbine housing by a Bolted Joint, of 6 equally spaced Hexagonal bolts. requirements:

1- The Standard Design Procedure

2-Design of Torque arm,

3-Design of the Bolted Joint

4-Design of the used Spur gear Pair

5-Design of main Input Shaft together with its KEY

6-Select the Right Deep Groove Ball bearings; which are supporting the main input Shaft, and Finally

7-The Configuration of the Main Input Shaft (Product Concept, DFM, DFA, Dimensions, Fits, and Tolerances for mating parts)

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

You know the right answer?

A Small-sized Wind Turbine is schematically shown in Fig (a), and is delivering a maximum rated powe...

Questions