Consider the system
xk+1= Axk+ Bμk
yk= Cxk+ Dμk
Required:
a. Determine whet...
Engineering, 04.07.2020 02:01 Weser17
Consider the system
xk+1= Axk+ Bμk
yk= Cxk+ Dμk
Required:
a. Determine whether the system is stable or not.
b. Determine whether the system is controllable and/or observable.
c. Compute its transfer function.
d. Compute the first five samples of its unit-step response, assume initial conditions of the states are 0.
Answers: 2
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
Engineering, 04.07.2019 18:20
Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process
Answers: 1
Engineering, 06.07.2019 03:20
An air-conditioning system consists of a heating section and an evaporative cooler. air enters the heating section at 10°c and 70 percent relative humidity at a rate of 30m^3/min, and it leaves the evaporative cooler at 20°c and 60 percent relatively humidity. if the air conditioning system operates at a total pressure of 98 kpa, determine (a) the temperature and relative humidity of the air when it leaves the heating section, (b) the rate of heat transfer in the heating section, and (c) the rate of water added to air in the evaporative cooler
Answers: 2
Engineering, 06.07.2019 05:20
Acantilever of 3 m length with a t-shaped cross-section is loaded by three concentrated loads: w,-80 n at the free end, w 30 n, and w,-60 n at a distance of 1 m from the free end. all loads are applied at the outer edges of the flange as indicated in the sketch below. (a)-determine the maximum torsional shear stresses in the flange and in the web at distances 0.5 m and 2.5 m from the free end (sections i and ii marked in the sketch) b)- determine thefh end cross section assuming a shear modulus of 210 gpa.
Answers: 3
English, 06.05.2020 20:03
Mathematics, 06.05.2020 20:03
Mathematics, 06.05.2020 20:03
English, 06.05.2020 20:03
Mathematics, 06.05.2020 20:03
English, 06.05.2020 20:03