Engineering, 03.07.2020 04:01 KIAZTUNEZ
Q1. A 3.phase full wave controlled rectifier is fed from 3-phase, 400V,50HZ source and is
connected to load taking a constant current of 35A. (a) Draw the waveform of output
voltage. (b) Calculate average value of load voltage for a firing angle of 20°
(c) average load power,
(30 mark)
Q2. Explain with necessary equation and drawing the principle operation of the boost
chopper
(35 mark)
Q3. A square wave output single phase bridge inverter supplies an 80 resistor with 40mH
inductance load. Load fundamental rms voltage is 135V at 60Hz. Calculate:
(a) voltage of the dc supply.
(b) rms value of load voltage, load current and third harmonic voltage.
(c) Load power
(35 mark)
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
You know the right answer?
Q1. A 3.phase full wave controlled rectifier is fed from 3-phase, 400V,50HZ source and is
connected...
Questions
History, 27.09.2019 05:20
