Engineering, 01.07.2020 15:01 tordiacasey

Consider the precipitation of a spherical B-rich phase (phase) from a dilute solution ( phase) of B in A. Suppose the original concentration of B in the solid solution is Co-5x10 atoms/cm', the diffusion coefficient of B is D-1010 cm/sec, and the interface transfer parameter of B is M-106 cm/sec. In a quasi-steady state, if the averaged concentration of B in the bulk (C) remains approximately the same as Co. and the concentration of B next to the auß interface is C 4x10 atoms/cm. what are the equilibrium concentration of B in the and the phases (Ca and Cb), when 21 the radius of the particle is r-um: 104 cm and grows at a rate (ar) of 10-7 cm/sec?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

Answer

You know the right answer?

Consider the precipitation of a spherical B-rich phase (phase) from a dilute solution ( phase) of B...