subject
Engineering, 20.06.2020 22:57 emilymariec4036

All of the questions in this problem are based on the circuit below. R=10Ω,L=5mH, C=500μF. The source voltage is 10cos(200t+45LaTeX: ^{^\circ} ∘ ). Round all of your answers to two decimal places if necessary. Omit the units. What is the inductor impedance value in ohms? First, what is the REAL part.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
question
Engineering, 04.07.2019 19:10
When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?
Answers: 2
You know the right answer?
All of the questions in this problem are based on the circuit below. R=10Ω,L=5mH, C=500μF. The sourc...
Questions
question
English, 25.11.2021 07:50
question
Mathematics, 25.11.2021 07:50
Questions on the website: 13722365